Echelon Stride-6s Open Box Treadmill Setup Guide

Quick Answer

Setting up your Echelon Stride-6s Certified Open Box treadmill is straightforward: unbox carefully, assemble the frame and console, connect power, and complete the on-screen touchscreen calibration. Follow these steps to avoid common pitfalls.

Stride-6s Open Box Setup Steps

1. 1. Unbox and Inspect: Remove the treadmill from the box and place it on a soft surface to avoid scratching the floor. Verify all parts against the included checklist: frame, console mast, hardware bag, power cord, safety key, and user manual. Common mistake: discarding foam blocks before checking for small parts tucked underneath.
2. 2. Attach the Console Mast: Lift the console mast upright and align it with the base frame. Insert the provided bolts and tighten them with the socket wrench. Do not fully tighten until the mast is perfectly vertical. Common mistake: cross-threading bolts by starting them at an angle. Hand-thread each bolt first, then use the wrench.
3. 3. Connect Console Cables: Gently feed the cable from the base through the mast and plug it into the console. Ensure the connector clicks into place. Common mistake: pinching the cable between frame pieces, which can cause display issues.
4. 4. Secure the Console: Place the console onto the mast and fasten it with the remaining screws. Tighten all bolts from step 2 now. Common mistake: forgetting to connect the safety key tether before final assembly. Double-check that the safety key is accessible.
5. 5. Power On and Calibrate Touchscreen: Plug the treadmill into a grounded outlet. Press the power switch. The 10″ HD touchscreen will prompt you to calibrate the display. Follow the on-screen instructions to tap the targets. Common mistake: skipping calibration, which can lead to inaccurate touch response. Run the full calibration cycle without interruption.
6. 6. Test and Adjust: Walk on the treadmill at a slow speed to ensure smooth belt movement and stable frame. Use the leveling feet under the rear of the frame if the treadmill wobbles. Common mistake: ignoring a wobble, which can worsen over time. Tighten or loosen leveling feet until all four contact the floor evenly.

Product Facts

• Echelon Stride-6s™ - 10″ HD Touchscreen (Certified Open Box): The Echelon Stride-6 S™ features a built-in 10″ HD touchscreen and Echelon’s open-front waterfall deck design with a softer running surface. The touchscreen eliminates the need for a separate tablet mount, and the deck reduces joint impact during your runs.